Inland M1 Carbine M1A1 Paratrooper Stock Rifle Scabbard .30 Semi Auto C&R
SOLD FOR: $2525
LSB#: 211006MW11
Make: Inland Division of General Motors
Model: M1 Carbine
A folding M1A1 Paratrooper Stock is included in the auction. The M1 Carbine action is not set in the Paratrooper stock because that would NOT be LEGAL in California.
Serial Number: 476023
Year of Manufacture: July to September, 1943 (page 28 of Scott Duff’s book The M1 Carbine Owner’s Guide).
Barrel Date: July, 1943
Caliber: .30 Carbine
Action Type: Semi Auto, Detachable Magazine
Markings: The partial import mark on the bottom of the barrel is in small text. It reads “ORD ARLINGTON VA”. The top of the receiver is marked “U.S. CARBINE / CAL. 30 M1” on the front and “INLAND DIV. / 476023” on the rear. The top of the barrel is marked “INLAND MFD. DIV. / GENERAL MOTORS / 7 – 43” and “P”. The right rear of the trigger group is marked “INLAND” which is an Inland mark (page 78 of Craig Riesch’s book, U.S. M1 Carbines Wartime Production 7th Edition). The hammer is marked “HI” which is an Inland mark (page 89). The magazine release is marked “EI” which is an Inland mark (pages 100-101). The smooth push button safety is unmarked which is consistent with Inland and others (page 95). The inside of the operating slide is marked “PI” which is an Inland mark (page 65). The bolt is marked “AI” on the left lug which is an Inland mark (page 36). The front sight is marked “N” which is consistent with Inland and others (page 56). The Type I rear sight is marked “S” on the right and “IN B” on the left which is an IBM mark (page 29). The Type IA barrel band is unmarked which is consistent with Inland and others (page 59).
The interior of the handguard is marked “OI” which is an Inland mark (page 138). The interior of the forearm is marked “OI” next to the magazine well wall which is correct for an M1A1 stock. This is an Inland mark. The inside of the buttplate is marked “B257614 * G” which is correct for an M1A1 stock (page 127).
The parachutist holster is marked “U.S.” on the flap and “ATLAS AWNING / 1943” on the interior.
Barrel Length: Approximately 18 Inches
Sights / Optics: The front sight is a post set between two protective wings. The rear sight is a Type I flip up dual aperture.
Stock Configuration & Condition: The M1A1 Paratrooper stock shows scrapes, scratches and compression marks. Some have damaged small areas of the surface wood. The grip area shows light runs in the finish. The leather on the buttsock shows edge scrapes, small compression marks, and discoloration. The buttstock metal shows small scrapes and areas of discoloration. The butstock folds and extends properly. The stock rates in about Very Good Plus overall condition as refinished.
Type of Finish: Parkerized
Finish Originality: Original
Bore Condition: The muzzle and the grooves near the muzzle are light grey. The rifling is sharp. There is fouling and intermittent erosion at the muzzle and in the grooves near the muzzle. The bore shows an M.E. of 1.8.
Overall Condition: This rifle retains about 90% of its metal finish. The metal shows scrapes, small scratches, and areas of thinning. The right front of the receiver shows a small area of surface erosion. The barrel shows areas of discoloration from oxidation. The markings are deep. Overall, this rifle rates in about Very Good Plus condition.
Mechanics: The action functions correctly. We did not fire this rifle. As with all used firearms, a thorough cleaning may be necessary to meet your maintenance requirements.
Box, Paperwork & Accessories: There is No magazine.
The rifle comes with a folding M1A1 Paratrooper stock; see above.
The rifle comes with a canvas M1A1 Parachutist Hip Holster (scabbard). The scabbard holds an M1 Carbine with a folded M1A1 stock. It shows areas of light soiling as well as light discoloration. It is in about Very Good Plus to Fine condition.
Our Assessment: The M1 Carbine was developed and produced after WWII started. Over 6 million were made by a number of U.S. companies to assist with the all out war effort. The M1 Carbine was widely issued to U.S. Military Forces which numbered over 16 million during WWII. The M1 Carbine contributed greatly to U.S. efforts during WWII.
The Inland Manufacturing Division of General Motors was organized in 1922 for the manufacturing of steering wheels. During WWII Inland Division was one of many facilities that tooled up to manufacture M1 Carbines for the war effort. Inland produced the majority of WWII M1 Carbines, about 43%, and contributed greatly to the war effort. Inland M1 Carbines were used by millions of soldiers during WWII in numerous battles. If you see WWII footage that includes an M1 Carbine, it is most likely an Inland M1 Carbine.
This Inland M1 Carbine was made back in 1943. It uses almost all Inland parts. It is 1 part short of being a “Matching” rifle. The rear sight was not made by Inland. This M1 Carbine comes with a folding M1A1 Paratrooper stock and a canvas M1A1 Parachutist Hip Holster (scabbard). The scabbard holds an M1 Carbine with a folded M1A1 stock. This is a nice package to add to your WWII collection. If you live in a Free State outside of California you can assemble the rifle and take it straight to the range. Good luck.